Seat LEON 2019 Owner's Manual page 264

smoothness with which the foot is removed
from the accelerator.
WARNING
If the inertia mode has been switched on,
●
take into account, when approaching an
obstacle, that the vehicle will not deceler-
ate in the usual manner: risk of accident!
When using inertia mode while travelling
●
down hills, the vehicle can increase speed:
risk of accident!
If other users drive your vehicle, warn
●
them about inertia mode.
Note
The driver message Inertia is only dis-
●
played with the current consumption. In in-
ertia mode the gear will no longer be dis-
played (for example "D" or "E" will appear
instead of "D7" or "E7").
The inertia mode will be automatically
●
disconnected on gradients steeper than
15%.
In the case of the TDI, TGI and 2.0l TSI en-
●
gines, the inertia mode will only work in the
driving mode.
Eco
262
Driving
Indications on the instrument panel
display
Clutch
Clutch overheating! Please stop!

The clutch has overheated and could be
damaged. Stop and wait for the gearbox to
cool with the engine at idling speed and the
selector lever in position P. When the warning
lamp and the driver message switch off, have
the fault corrected by a specialised work-
shop without delay. If they do not turn off, do
not continue driving. Seek specialist assis-
tance.
Faults in the gearbox
Gearbox: Fault! Stop the vehicle

and place the lever in the posi-
tion P.
There is a fault in the gearbox. Stop the vehi-
cle in a safe place and do not continue driv-
ing. Seek specialist assistance.
Gearbox: System fault! You may

continue driving.
Have the fault corrected by a specialised
workshop without delay.
Gearbox: System fault! You can

continue driving with restric-
tions. Reverse gear disabled
Take the vehicle to a specialised workshop
and have the fault repaired.
Gearbox: System fault! You can

continue driving in D until
switching off the engine
Park the vehicle in a safe place. Seek special-
ist assistance.
Gearbox: too hot. Adapt your

driving accordingly
Continue driving at moderate speeds. When
the warning lamp switches off, you can con-
tinue driving in a normal manner.
Gearbox: press the brake and en-

gage a gear again.
If the warning was caused by the tempera-
ture of the gearbox, this driver message will
be displayed when the gearbox has cooled
again.