Seat LEON 2019 Owner's Manual page 60

Light source used for each function
Halogen headlights.
Daytime running light/side
light
Dipped beam headlights
Main beam headlights
Turn signal
Full-LED main head-
lights
No bulbs may be replaced. All functions are with
LEDs
Front fog light
Fog/cornering lights*
Rear lights
Brake light/tail light
Side lights
Turn signal
Retro fog light
Reverse lights
LED rear lights
Reverse lights
The remaining functions work with LEDs
58
WARNING
Type
Take particular care when working on
●
components in the engine compartment if
P21W SLL the engine is warm. Risk of burns.
Bulbs are highly sensitive to pressure. The
●
H7 LL
glass can break when you touch the bulb,
causing injury.
H7 LL
When changing bulbs, please take care
●
PY21W LL
not to injure yourself on sharp edges, in
particular on the headlight housing.
Type
CAUTION
Remove the ignition key before working
●
on the electric system. Otherwise, a short
circuit could occur.
Type
Switch off the lights and the parking light
●
before changing a bulb.
H8
Take good care to avoid damaging any
●
components.
Type
P21W LL
For the sake of the environment
2x W5W LL
Please ask your specialist retailer how to
dispose of used bulbs in the proper manner.
PY21W LL
H21W
Note
P21W LL
Please check at regular intervals that all
●
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
Type
not only in the interest of your own safety,
W16W
but also that of all other road users.
Emergencies
Before changing a bulb, make sure you
●
have the correct new bulb.
Do not touch the glass part of the bulb
●
with your bare hands, use a cloth or paper
towel instead, since the fingerprints left on
the glass will vaporise as a result of the
heat generated by the bulb, they will be
deposited on the reflector and will impair
its surface.
Depending on the level of equipment fit-
●
ted in the vehicle, LEDs may be used for
part or all of the interior and/or exterior
lighting. LEDs have an estimated life that
exceeds than that of the car. If an LED light
fails, go to an authorised workshop for its
replacement.