WAGO 750-370 Manual page 114

114 • PROFINET IO 750-370
SNMP configuration
Fig. 3.1.10-13: Web-based Management
During "SNMP Configuration," both the device name (sysName) and device
description (sysDescription), as well as location (sysLocation) and contact
(sysContact), can be set.
In the "SNMP v1/v2c (connection-based)" header, the following can occur:
• first, the connection can be enabled
• the IP address of the SNMP manager used can be set
• the community string can be defined
• and traps/notifications in versions 1 and 2c can be switched independently
These settings can be configured for two independent SNMP managers.
SNMPv3 settings are made in the "SNMPv3 (user-based)" area. First, the user
can be activated under "activate." If an "Authentication Type" is selected as
encryption of the authentication, then both a "Security Authentication Name"
and an "Authentication Key" must be entered. In addition, user data
p037001x
WAGO-I/O-SYSTEM 750
PROFINET IO