Network Communication; Protocol Layer Model - WAGO 750-370 Manual

142 • Fieldbus Communication
ETHERNET

4.1.3 Network Communication

Fieldbus communication between master application and (programmable)
fieldbus coupler or controller usually takes place using an implemented
fieldbus specific application protocol, e. g. MODBUS TCP (UDP),
EtherNet/IP, BACnet, KNXNET/IP, PROFINET, Powerlink, SERCOS III or
others.
The protocol layer model helps with an example (MODBUS and EtherNet/IP)
to explain the classification and interrelationships between the communication
and application protocols.
In this example, the fieldbus communication can take place using either the
MODBUS protocol or EtherNet/IP.
4.1.3.1

Protocol layer model

(1) ETHERNET:
The ETHERNET hardware forms the basis for the physical exchange of data.
The exchanged data signals and the bus access procedure CSMA/CD are
defined in a standard.
(2) IP:
For the communication the Internet Protocol (IP) is positioned above the
ETHERNET hardware. This bundles the data to be transmitted in packets
along with sender and receiver address and passes these packets down to the
ETHERNET layer for physical transmission. At the receiver end, IP accepts
the packets from the ETHERNET layer and unpacks them.
(3) TCP, UDP:
a) TCP: (Transmission Control Protocol)
The TCP protocol, which is positioned above the IP layer, monitors
the transport of the data packets, sorts their sequence and sends
repeat requests for missing packets. TCP is a connection-oriented
transport protocol.
The TCP and IP protocol layers are also jointly described as the
TCP/IP protocol stack or TCP/IP stack.
b) UDP: (User Datagram Protocol)
The UDP layer is also a transport protocol like TCP, and is
arranged above the IP layer. In contrast to the TCP protocol, UDP
is not connection oriented. That means there are no monitoring
mechanisms for data exchange between sender and receiver.
(1)
(physical interface, CSMA/CD)
(2)
(1)
(physical interface, CSMA/CD)
ETHERNET
IP
ETHERNET
WAGO-I/O-SYSTEM 750
PROFINET IO