WAGO 750-370 Manual page 102

102 • PROFINET IO 750-370
Diagnostics
Invalid module configurations are reported via manufacturer specific fault of
type 101
Fault type "Configuration fault (0x0101)"
Extended
fault type
If a fault occurs on the internal data bus system when the PNIO connection is
being established and if auto reset of the internal data bus was set by the
station proxy, then the PNIO connection must be interrupted and re-
established in order to set the parameters of the connected I/O modules. The
reconfiguration request is triggered by a manufacturer specific fault of type
102
Fault type "Reconfiguration required (0x0102)"
Extended
fault type
. Additional fault information is available in the following table.
H
Additional
value
0x0012 0xC0018012 The bit offset for the inputs of the module is not allowed.
0x0013 0xC0018013 The bit offset for the inputs of the module exceed the
0x0015 0xC0018015 The configured data length for the input module are smaller
0x0016 0xC0018016 The configured data length for the input module are larger
0x0017 0xC0018017 The configured data length for the input module is not
0x0022 0xC0018022 The bit offset for the output of the module is not allowed.
0x0023 0xC0018023 The bit offset for the output of the module exceed the
0x0025 0xC0018025 The configured data length for the output module is smaller
0x0026 0xC0018026 The configured data length for the output module is larger
0x0027 0xC0018027 The configured data length for the output module is not
. Additional fault information is available in the following table.
H
Additional
value
0x00B9 0xC00180B9 Configuration is requested due to an internal data bus fault.
Description
maximum offset.
than expected.
than expected.
allowed.
maximum offset.
than expected.
than expected.
allowed.
Description
This can be performed via interruption and re-establishment
of the PNIO connection.
WAGO-I/O-SYSTEM 750
PROFINET IO