Rigol MSO1000Z Series Programming Manual page 73

Chapter 2 Command System
:DECoder<n>:PARallel:EDGE
Syntax :DECoder<n>:PARallel:EDGE <edge>
:DECoder<n>:PARallel:EDGE?
Description Set or query the edge type of the clock channel when the instrument samples the data
channel in parallel decoding.
Parameter
Name
<n>
<edge>
Explanation If no clock channel is selected (:DECoder<n>:PARallel:CLK), the instrument will sample
when the channel data jumps.
Return The query returns RISE, FALL, or BOTH.
Format
Example :DECoder1:PARallel:EDGE BOTH
:DECoder1:PARallel:EDGE?
:DECoder<n>:PARallel:WIDTh
Syntax :DECoder<n>:PARallel:WIDTh <wid>
:DECoder<n>:PARallel:WIDTh?
Description Set or query the data width (namely the number of bits of each frame of data) of the
parallel bus.
Parameter
Name
<n>
<wid>
Explanation After setting the data width using this command, send the
and :DECoder<n>:PARallel:SOURce
source for each bit respectively.
Return The query returns an integer between 1 and 16.
Format
Example :DECoder1:PARallel:WIDTh 16
:DECoder1:PARallel:WIDTh?
MSO1000Z/DS1000Z Programming Guide
Type Range
Discrete {1|2}
Discrete {RISE|FALL|BOTH}
Type Range
Discrete {1|2}
integer 1 to 16
/*Set the data width in parallel decoding to 16*/
/*The query returns 16*/
/*Set the oscilloscope to sample data on any edge
of the clock channel in parallel decoding*/
/*The query returns BOTH*/
commands to select each bit and set the channel
Default
--
RISE
Default
--
8
:DECoder<n>:PARallel:BITX
RIGOL
2-57