Rigol MSO1000Z Series Programming Manual page 129

Chapter 2 Command System
-Pulses:
+Edges:
-Edges:
3. Delay and Phase
Delay 1→2:
Delay 1→2:
Phase 1→2:
Phase 1→2:
Wherein,
Phase
or "Delay 1→2" and
Source 1
Source 2
MSO1000Z/DS1000Z Programming Guide
The number of negative pulses that fall from above the threshold upper limit to
below the threshold lower limit.
1
The number of rising edges that rise from below the threshold lower limit to above
the threshold upper limit.
1
The number of falling edges that fall from above the threshold upper limit to below
the threshold lower limit.
1
The time difference between the rising edges of source 1 and source 2. Negative
delay indicates that the selected rising edge of source 1 occurred after the selected
rising edge of source 2.
The time difference between the falling edges of source 1 and source 2. Negative
delay indicates that the selected falling edge of source 1 occurred after the selected
falling edge of source 2.
Phase difference calculated according to "Delay
1, expressed in degree. The calculation formula is as shown below.
Phase difference calculated according to "Delay
1, expressed in degree.The calculation formula is as shown below.
Phase
denotes "Phase 1→2" or "Phase
denotes the period of source 1.
Period 1
Period
-Pulses=n
2 n
+Edges=n
2 n
-Edges=n
2 n
Delay
  
360
Period 1
1→2", Delay denotes "Delay
Delay
Threshold
Upper Limit
Threshold
Lower Limit
Threshold
Upper Limit
Threshold
Lower Limit
Threshold
Upper Limit
Threshold
Lower Limit
1→2" and the period of source
1→2" and the period of source
RIGOL
1→2"
2-113