Safety Instructions - IFM Electronic Ecomat 300 AL1030 Device Manual

IO-Link Master EtherCat

2 Safety instructions

These instructions contain texts and figures concerning the correct handling of the
device and must be read before installation or use
Observe the operating instructions Non-observance of the instructions, operation
which is not in accordance with use as prescribed below, wrong installation or
incorrect handling can seriously affect the safety of operators and machinery
► Prepare installation
► Disconnect the device
► Ensure that devices cannot be accidentally restarted
► Verify safe isolation from the supply
► Earth and short circuit
► Cover or enclose adjacent units that are live
► Follow the specific mounting instructions of the device
► Only suitably qualified personnel in accordance with EN 50 110-1/-2 (VDC 0105
part 100) is permitted to work on this device/system
► Before installation and before touching the device ensure that you are free of
electrostatic charge
► The functional earth (FE) must be connected to the protective earth (PE) or to
the potential equalisation The system installer is responsible for implementing
this connection
► Connecting cables and signal lines must be installed in such a manner that
inductive or capacitive interference do not impair the automatic functions
► Install automation equipment and related operating elements in such a way that
they are protected against unintentional operation
► Suitable safety hardware and software measures should be implemented for
the I/O interface so that a line or wire breakage on the signal side does not
result in undefined states in the automation device
► Ensure a reliable electrical isolation of the low voltage for the 24 V supply
Only use power supplies compliant with IEC 60 364-4-41 or HD 384441 S2
(VDE 0100 part 410)
► Fluctuations or deviations of the mains voltage from the rated value must not
exceed the tolerance limits specified in the technical data; otherwise this may
cause malfunction and dangerous operation
► E-stop devices to IEC/EN 60 204-1 must be effective in all operating modes of
the automation device Unlatching the e-stop devices must not cause restart
6