241 Io-Link Device Setting (Configured) - IFM Electronic Ecomat 300 AL1030 Device Manual

IO-Link Master EtherCat
The IO-Link master is identified as MDP Profile Implementation "5001" For this reason, the objects
F030 (Configured Module Ident List) and F050
hex
module identification in case of an MDP device must be available
Since the IO-Link functions according to the IO-Link Master Profile Implementation "6220", these
objects are not evaluated by the device since identification via Vendor ID and Device ID is sufficient
No adjustment of the module numbers is made
The entries of object F030
configured IO-Link devices which (read from the ESI file) are written into the sub-object 8xx0:0A
during the start-up
The entries of object F050
detected IO-Link devices, both are filled with zeros
24.1 IO-Link device setting (configured)
For each IO-Link port, the objects 8000
device-specific configuration data like Device ID, Vendor ID, process data length,
etc
The IO-Link master writes all configuration data to the IO-Link master during
start-up, status change from PREOP to SAFEOP In the OP status, they can be
acyclically read or changed by the EtherCat master
42
hex
correspond with the entries in the sub-indexes 0x8nn0:0A of the
hex
correspond with the entries in the sub-indexes 0x9nn0:0A of the
hex
to 8070
hex
(Detected Module Ident List) which are used for
contain the manually defined
hex