Configuring Forced Failure - Cisco SCE 8000 10GBE Software Configuration Manual

Configuring Forced Failure

Configuring Forced Failure
Use the following commands to force a virtual failure condition, and to exit from the failure condition
when performing an application upgrade.
From the SCE(config if)# prompt, type:
Commands
force failure-condition
no force failure-condition
Cisco SCE 8000 10GBE Software Configuration Guide
11-18
Chapter 11
Purpose
Forces the Cisco SCE platform into a virtual
failure state.
Exits from the virtual failure state.
Redundancy and Failover
OL-30621-02