Configuring Snmp Server Group; Configuring Snmp Server View - Cisco SCE 8000 10GBE Software Configuration Manual

Configuring and Managing the SNMP Interface
Following are some sample procedures illustrating how to do the following:
•
•
•
•
•
•
•
•

Configuring SNMP Server Group

Use this command to configure the SNMPv3 server group on the Cisco SCE platform.
At the SCE(config)# prompt, type:
Command
snmp-server group groupname 3 {
noAuthNoPriv| authNoPriv | authPriv}}
[read-view view-name] [write-view write-view]
Options
The following options are available:
•
•
•
•
•
•

Configuring SNMP Server View

Use this command to configure the SNMP v3 server view on the Cisco SCE platform.
At the SCE(config)# prompt, type:
Cisco SCE 8000 10GBE Software Configuration Guide
5-48
(SNMPv3 only) Configure SNMP Server View
(SNMPv3 only) Configure SNMP Server Group
(SNMPv3 only) Configuration SNMP Server User
Configure hosts (NMS) to which the SNMP agent should send notifications
Remove/disable a host (NMS) from receiving notifications
Enable the SNMP agent to send authentication-failure notifications
Enable the SNMP agent to send enterprise notifications
Reset all notifications to the default setting
groupname—Name of the server group.
noAuthNoPriv—Sets the security level to no authentication and no privacy.Group does not require
any authentication or encryption security levels for access.
authNoPriv—Sets the security level with authentication and no privacy. The users of this group has
to authenticate themselves to get access.
authPriv—Sets the security level with authentication and privacy. The users of this group requires
both authentication and encryption security levels for access.
read-view—(Optional)Specifies that the view is a read-view. This is the view used for
SNMPGET/GET-NEXT/WALK.
write-view—(Optional)Specifies that the view is a write-view. This is the view used for SNMPSET.
Chapter 5 Configuring the Management Interface and Security
Purpose
Configure the SNMPv3 server group on the Cisco
SCE platform.
The server group details are included in the
running-configuration.
By default an SNMP group is read-only.
OL-30621-02