Ip Advertising; Configuring Ip Advertising - Cisco SCE 8000 10GBE Software Configuration Manual

IP Routing Configuration
How to Display the IP Routing Table for a Specified Subnet
Options
The following options are available:
•
•
From the SCE# prompt, type:
Command
show ip route prefix mask
Displaying the IP Routing Table for a Specified Subnet: Example
This example shows how to display the routing table for a specified subnet.
SCE#show ip route 10.1.60.0 255.255.255.0
|
|-----------------|-----------------|-----------------|
|
sce#

IP Advertising

•
•
IP advertising is the act of periodically sending ping requests to a configured address at configured
intervals. This maintains the Cisco SCE platform IP/MAC addresses in the memory of adaptive network
elements, such as switches, even during a long period of inactivity.
The following commands are relevant to IP advertising:
•
•
•
•
•
•
•
•

Configuring IP Advertising

To configure IP advertising, you must first enable IP advertising. You may then specify a destination
address to which the ping request is to be sent and/or the frequency of the ping requests (interval). If no
destination or interval is explicitly configured, the default values are assumed.
Cisco SCE 8000 10GBE Software Configuration Guide
6-4
prefix—IP address of the routing entry, in dotted notation.
mask—The relevant subnet mask, in dotted notation
prefix | mask
10.1.60.0 | 255.255.255.0 |
Configuring IP Advertising, page 6-4
How to Display the Current IP Advertising Configuration, page 6-5
[no] ip advertising
ip advertising destination
ip advertising interval
default ip advertising destination
default ip advertising interval
show ip advertising
show ip advertising destination
show ip advertising interval
Purpose
Displays the routing table for the specified subnet
(prefix/mask).
| next hop |
10.1.1.5 |
Chapter 6 Global Configuration
OL-30621-02