Configuring A Vas Server Group - Cisco SCE 8000 10GBE Software Configuration Manual

Configuring VAS Traffic Forwarding
Options
The following options are available:
•
•
How to Define the Pseudo IP Address
Use this command to define the pseudo IP address to be used for the health check.
From the SCE(config if)#>prompt, type:
Command
pseudo-ip ip-address [mask]
How to Delete the Pseudo IP Address
From the SCE(config if)#>prompt, type:
Command
no pseudo-ip ip-address [mask]

Configuring a VAS Server Group

You may define up to eight VAS server groups. Each VAS server group has the following parameters:
•
•
•
•
You can perform these operations for a VAS server group:
•
•
•
Cisco SCE 8000 10GBE Software Configuration Guide
14-28
ip-address—IP address to be used (any IP address as long as it is not possible to be found in the
network traffic, such as a private IP)
– Default—no IP address
mask (optional)—Defines the range of IP addresses that can be used by the Cisco SCE platform.
Note that the Cisco SCE platform is not required to reside in this subnet.
– Default—255.255.255.255 (The subnet mask can be set to 255.255.255.255, as the health check
mechanism requires only one IP address per interface.)
Server Group ID
A list of VAS servers attached to this group.
Failure detection—minimum number of active servers required for this group so it will be
considered to be Active. If the number of active servers goes below this minimum, the group will be
in Failure state.
Failure action—action performed on all new data flows that should be mapped to this Server Group
while it is in Failure state.
Options:
block
–
pass
–
Add a VAS server to or remove a VAS server from a specified group.
Configure the minimum number of active servers for a specified group.
Configure failure behavior for a specified group.
Chapter 14 Value-Added Services (VAS) Traffic Forwarding
Purpose
Defines the pseudo IP address.
Purpose
Deletes the pseudo IP address.
OL-30621-02