Configuring Name Servers - Cisco SCE 8000 10GBE Software Configuration Manual

Domain Name Server (DNS) Settings

Configuring Name Servers

•
•
•
•
Options
The following options are available:
•
How to Define Domain Name Servers
Use this command to specify the address of one or more name servers to use for name and address
resolution.
From the SCE(config)# prompt, type:
Command
ip name-server server-address1
[server-address2 [server-address3]]
Defining Domain Name Servers: Example
The following example shows how to configure the two name server (DNS) IP addresses.
SCE(config)#ip name-server 10.1.1.60 10.1.1.61
How to Remove a Domain Name Server
From the SCE(config)# prompt, type:
Command
no ip name-server server-address1
[server-address2 [server-address3]]
Removing a Domain Name Server: Example
The following example shows how to remove name server (DNS) IP addresses.
SCE(config)#no ip name-server 10.1.1.60 10.1.1.61
Cisco SCE 8000 10GBE Software Configuration Guide
6-18
Options, page 6-18
How to Define Domain Name Servers, page 6-18
How to Remove a Domain Name Server, page 6-18
How to Remove All Domain Name Servers, page 6-19
server-ip-address—The IP address of the domain name server. You can define more than one DNS
server (server-ip-address1, server-ip-address2, server-ip-address3)
Chapter 6
Purpose
Defines the servers at the specified addresses as
domain name servers.
Purpose
Removes the specified server from the DNS list.
Global Configuration
OL-30621-02