Creating Anonymous Groups - Cisco SCE 8000 10GBE Software Configuration Manual

Creating Anonymous Groups

Creating Anonymous Groups
You can create anonymous groups in two ways:
•
•
•
For information on deleting anonymous groups, see
Group" section on page 10-14
page 10-14
Defining Anonymous Groups
Use this command to define an anonymous group, assigning the following to the group created:
•
•
•
How to Define an Anonymous Group
Options
The following options are available:
•
•
•
From the SCE(config if)# prompt, type:
Command
subscriber anonymous-group name group-name
ip-range range [template template]
subscriber anonymous-group name group-name
ipv6-range ipv6-address/prefix [template
template]
Cisco SCE 8000 10GBE Software Configuration Guide
10-18
Define the group, along with the related IP address range, using the subscriber anonymous-group
command. The Cisco SCE platform then generates anonymous subscribers for that group when it
detects traffic with an IP address that is in the specified IP range.
Create the group by importing anonymous groups from a csv file.
Groups can also be exported to a csv file.
Maximum creation rate of anonymous subscribers is 360 per second on the Cisco SCE 8000 and 180
per second on the Cisco SCE2020.
group name
range of IP addresses
subscriber template to be assigned to all subscribers within that IP range (optional)
group-name—Name to be assigned to the anonymous group.
range—Range of IP addresses that defines this group.
template—Number of the subscriber template to assign to all subscribers in this group.
Default = 0
"How to Remove a Specific Anonymous Subscriber
and "How to Remove All Anonymous Subscriber Groups" section on
Purpose
Defines an anonymous group for IPv4.
If no template is specified, the default template is
applied to all subscribers in this group.
Defines an anonymous group for IPv6.
If no template is specified, the default template is
applied to all subscribers in this group.
Chapter 10 Managing Subscribers
OL-30621-02