Specifying The Active Management Port - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 5 Configuring the Management Interface and Security
How to Configure the Duplex Operation of the Management Interface
Options
The following options are available:
•
If the speed parameter is configured to auto, changing the duplex parameter has no effect.
Step 1 Access the interface configuration mode for the management interface you want to configure.
From the SCE(config)# prompt, type interface Mng (0/1 | 0/2) and press Enter.
From the SCE(config if)# prompt, type duplex auto|full|half and press Enter.
Step 2
Specify the desired duplex option.
Configuring the Duplex Operation of the Management Interface: Example
The following example shows how to use this command to configure the management port to half duplex
mode.
SCE#config
SCE(config)#interface mng 0/2
SCE(config if)#duplex half

Specifying the Active Management Port

This command explicitly specifies which management port is currently active. Its use varies slightly,
depending on whether the management interface is configured as a redundant interface (auto failover
enabled) or not (auto failover disabled).
•
•
Access the interface configuration mode for the management interface you want to configure as the
Step 1
active management port.
From the SCE(config)# prompt, type interface Mng (0/1 | 0/2) and press Enter.
Step 2 Type active-port and press Enter
OL-30621-02
duplex—Duplex operation of the management port (0/1 or 0/2):
full
–
half
–
auto (default)—Auto-negotiation (do not force duplex on the link)
–
auto failover enabled (automatic mode)—The specified port becomes the currently active port, in
effect forcing a failover action even if a failure has not occurred.
auto failover disabled (manual mode)—The specified port should correspond to the cabled Mng
port, which is the only functional port and therefore must be and remain the active management port.
Configuring the Management Ports
Cisco SCE 8000 10GBE Software Configuration Guide
5-7