Configuring The Cisco Sce Platform Tacacs+ Client - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 5 Configuring the Management Interface and Security

Configuring the Cisco SCE Platform TACACS+ Client

•
•
•
•
The user must configure the remote servers for the TACACS+ protocol. Then the Cisco SCE platform
TACACS+ client must be configured to work with the TACACS+ servers. The following information
must be configured:
•
•
•
The procedures for configuring the Cisco SCE platform TACACS+ client are explained in the following
sections:
•
•
•
•
Adding a New TACACS+ Server Host
Use this command to define a new TACACS+ server host that is available to the Cisco SCE platform
TACACS+ client.
The Service Control solution supports a maximum of three TACACS+ server hosts.
OL-30621-02
Adding a New TACACS+ Server Host, page 5-19
Removing a TACACS+ Server Host, page 5-20
Configuring the Global Default Key, page 5-20
Configuring the Global Default Timeout, page 5-21
TACACS+ server hosts definition—A maximum of three servers is supported.
For each sever host, the following information can be configured:
hostname (required)
–
port
–
encryption key
–
timeout interval
–
Default encryption key (optional)—A global default encryption key may be defined. This key is
defined as the key for any server host for which a key is not explicitly configured when the server
host is defined.
If the default encryption key is not configured, a default of no key is assigned to any server for which
a key is not explicitly configured.
Default timeout interval (optional)—A global default timeout interval may be defined. This timeout
interval is defined as the timeout interval for any server host for which a timeout interval is not
explicitly configured when the server host is defined.
If the default timeout interval is not configured, a default of five seconds is assigned to any server
for which a timeout interval is not explicitly configured.
Adding a New TACACS+ Server Host, page 5-19
Removing a TACACS+ Server Host, page 5-20
Configuring the Global Default Key, page 5-20
Configuring the Global Default Timeout, page 5-21
TACACS+ Authentication, Authorization, and Accounting
Cisco SCE 8000 10GBE Software Configuration Guide
5-19