Authorization And Command Mode Levels (Hierarchy) - Cisco SCE 8000 10GBE Software Configuration Manual

Authorization and Command Mode Levels (Hierarchy)

Authorization and Command Mode Levels (Hierarchy)
When using the CLI there are two important concepts that you must understand to navigate:
•
•
The following sections describe the available Authorization and Command Hierarchy Levels and how to
maneuver within them.
The on-screen prompt indicates both your authorization level and your command hierarchy level, as well
as the assigned hostname.
Throughout the manual,
Note
CLI Authorization Levels
The Cisco SCE platform has four authorization levels, which represent the user access permissions.
When you initially connect to the Cisco SCE platform, you automatically have the most basic
authorization level, that is User, which allows minimum functionality.
To monitor the system, you must have Viewer authorization, while to perform administrative functions
on the Cisco SCE platform, you must have Admin or Root authorization. A higher level of authorization
is accessed by logging in with appropriate password, as described in the procedures below.
In each authorization level, all the commands of the lower authorization layers are available in addition
to commands that are authorized only to the current level.
The following CLI commands are related to authorization levels:
•
•
Each authorization level has a value (number) corresponding to it. When using the CLI commands, use
the values, not the name of the level, as shown in
Table 2-1
Level
User
Viewer
Cisco SCE 8000 10GBE Software Configuration Guide
2-2
Authorization Level—Indicates the level of commands you can execute. A user with a simple
authorization level can only view some information in the system, while a higher level administrator
can actually make changes to configuration.
This manual documents commands up to and including the admin authorization level.
Command Hierarchy Level—Provides you with a context for initiating commands. Commands are
broken down into categories and you can only execute each command within the context of its
category. For example, to configure parameters related to the Line Card, you need to be within the
Linecard Interface Configuration Mode. (See
page 2-3.)
is used as the sample host name.
SCE
enable
disable
Authorization Levels
Description
Password required. This level enables basic operational
functionality.
Password required. This level enables monitoring
functionality. All show commands are available to the
Viewer authorization level, with the exception of those that
display password information.
Chapter 2
"CLI Command Mode Hierarchy" section on
Table 2-1.
Value
0
5
Command-Line Interface
Prompt
>
>
OL-30621-02