Rebooting And Shutting Down The Cisco Sce Platform; Rebooting The Cisco Sce Platform; Examples For Rebooting The Cisco Sce Platform; How To Shut Down The Cisco Sce Platform - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 3 Basic Cisco SCE 8000 Platform Operations

Rebooting and Shutting Down the Cisco SCE Platform

•
•

Rebooting the Cisco SCE Platform

Rebooting the Cisco SCE platform is required after installing a new package, in order for that package
to take effect. There might be other occasions where rebooting the Cisco SCE platform is necessary.
When the Cisco SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
At the SCE# prompt, enter reload and press Enter.
Step 1
A confirmation message appears.
Press Enter to confirm the reboot request (accept default, which is Yes).
Step 2

Examples for Rebooting the Cisco SCE Platform

The following example shows the commands for system reboot.
SCE# reload

Are you sure? Y. 
the system is about to reboot, this will end your CLI session

How to Shut Down the Cisco SCE Platform

Shutting down the Cisco SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the Cisco SCE platform are properly flushed in an orderly manner.
When the Cisco SCE platform restarts, it loads the startup configuration, so all changes made in the
Note
running configuration will be lost. You are advised to save the running configuration before performing
reload, as described in
Connect to the serial console port (The CON connector on the front panel of the Service Control module
Step 1
in slot #1, 9600 baud).
The SCE# prompt appears.
Type reload shutdown.
Step 2
A confirmation message appears.
OL-30621-02
Rebooting the Cisco SCE Platform, page 3-23
How to Shut Down the Cisco SCE Platform, page 3-23
"How to Save or Change the Configuration Settings" section on page
"How to Save or Change the Configuration Settings" section on page

Rebooting and Shutting Down the Cisco SCE Platform

Cisco SCE 8000 10GBE Software Configuration Guide
3-6.
3-6.
3-23