Ametek DR6500 Handbook page 108

OPERATION
6
Status Error message
type
F F F F Configuration Configuration Configuration Configuration
Inconsistent NVRAM
Incons. Converter Calib.
Incons. Sensor Calibration
NVRAMs Mismatch
Conv. NVRAM Layout Error
Disp. NVRAM Layout Error
CO Float Error
C C C C Electronics Electronics Electronics Electronics
FW Update
108
Description
Incorrect data in the parameter
memory.
Incorrect calibration data in the
converter module.
Incorrect calibration data in the
sensor module.
The serial number of the display
screen does not agree with the
serial number of the electronics
module.
Incorrect data in the parameter
memory.
Incorrect data after an update of
the firmware.
The device cannot use the
2
measurement data because the
device settings are incorrect.
A firmware update of the
converter module continues.
www.drexelbrook.com
Corrective action
De-energize and then energize the
device again.
If the message is shown again, tell
the supplier.
Tell the supplier.
Make sure that the display screen
agrees with the electronic module.
Go to Full Setup Full Setup > Device Device >
Full Setup Full Setup Device Device
Information Information and record the data in Information Information
menu items C7.1.5 Electronic C7.1.5 Electronic C7.1.5 Electronic C7.1.5 Electronic
Revision Revision and C7.1.6 Software C7.1.6 Software
Revision Revision C7.1.6 Software C7.1.6 Software
Revision Revision Revision. If it is necessary, tell the Revision
supplier.
De-energize and then energize the
device again.
If the message is shown again, tell
the supplier.
You must make the device go back
to its factory settings. Enter
Program mode. Set the device to
the "Expert" access level. Go to
Full Setup > Device Full Setup Device > Factory Factory
Full Setup Full Setup Device Device Factory Factory
Default Default > Reset to Factory Reset to Factory
Default Default Reset to Factory Reset to Factory
Default? Default? Default? Default? and set this menu item to
"Yes". Then go back to Normal
mode and set the "Save
Configuration?" page to "Yes". De-
energize and then energize the
device again.
If the message is shown again, tell
the supplier.
Wait for the firmware update to
finish.
DR6500-PM-English-Issue 1
DR6500