Ametek DR6500 Handbook page 89

DR6500
Menu Function
No.
C7.2.3 Reset
Passwords
C7.2.4 Unlock
Extended Range
C7.2.5 Unlock SIL
C7.3 Errors C7.3 Errors C7.3 Errors C7.3 Errors
C7.3.1 Message View
C7.3.2 Error-Mapping
C7.3.2.1 Sensor:
Information
C7.5 Units
C7.5.1 Length
C7.5.2 Cst. Length
C7.5.2.1 Text
C7.5.2.2 Offset
C7.5.2.3 Factor
C7.5.3 Volume
C7.5.4 Cst. Volume
C7.5.4.1 Text
C7.5.4.2 Offset
C7.5.4.3 Factor
DR6500-PM-English-Issue 1
Function description
This is a special password that makes your
passwords for the "operator" and "expert"
access levels go back to the default
passwords. This password is supplied on
request by the after-sales service
department.
This menu item can only be unlocked at the
factory.
This menu item can only be unlocked at the
factory.
A log of device errors. Scroll down the list
and push [> > > > ] to show the error details. The
error will have a letter code ("F", "S", "M",
"C" and "I") that agrees with NAMUR NE 107
Guidelines.
This permits you to change the error code
that is given to an incident.
Minimum access level to change the Minimum access level to change the Minimum access level to change the Minimum access level to change the
setting: User setting:
setting: setting:
The length unit shown in Normal mode. If
you set this menu item to "Cst." (custom
length unit), enter values in menu items
C7.5.2.1 thru C7.5.2.3.
Minimum access level to change the Minimum access level to change the
Minimum access level to change the Minimum access level to change the
setting: User setting: setting: setting:
Enter a text (8 characters maximum) for the
custom length unit.
Enter an offset value.
Enter a factor. Multiply the measured value
by this factor to change m (metres) to the
custom length unit.
The volume unit shown in Normal mode if
you made a volume table in the C3
Conversion menu. If you set this menu item
to "Cst. Volume" (custom volume unit),
enter values in menu items C7.5.4.1 thru
C7.5.4.3.
Minimum access level to change the Minimum access level to change the
Minimum access level to change the Minimum access level to change the
setting: User setting: setting: setting:
Enter a text (8 characters maximum) for the
custom volume unit.
Enter an offset value.
Enter a factor. Multiply the measured value
by this factor to change m³ (cubic metres) to
the custom volume unit.
www.drexelbrook.com
OPERATION
Selection list
—
—
—
Read only
None, Information (I),
Maintenance Request
(M), Out of Specification
(S), Function Check (C),
Failure (F)
m, cm, mm, ft, in, Cst.
—
—
—
m³, L, hL, in³, ft³, gal,
ImpGal, yd³, bbl, bbl
(beer, US), Cst. Volume
—
—
—
6
Default
—
—
—
—
Information
m
Cst.
0.0 m
1.0
m³
Cst.
0.0 m³
1.0
89