Table of Contents
Advertisement
DR6500
Menu
Function
No.
C4.1.7
Low Error
Current
C4.1.8
High Error
Current
C4.1.9 Trimming
C4.1.9.2
4mA Trimming
C4.1.9.5
20mA Trimming
C5 Communication
C5.1 HART
C5.1 HART
C5.1 HART
C5.1 HART
C5.1.1
Current Loop
Mode
C5.1.2 Identification
C5.1.2.1
Polling Address
C5.1.2.2
Tag
DR6500-PM-English-Issue 1
Function description
This menu item is available if C4.1.5 Error
Function is set to "Low". You can change the
value to which the current output will
change if an error occurs.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting:
setting:
setting: Expert
This menu item is available if C4.1.5 Error
Function is set to "High". You can change
the value to which the current output will
change if an error occurs.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting:
setting:
setting: Expert
Use this menu item if the current output of
the device is set to 4 mA, but the measured
loop current is not 4 mA. Enter the
measured value.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting: Expert
setting:
setting:
setting:
Use this menu item if the current output of
the device is set to 20 mA, but the measured
loop current is not 20 mA. Enter the
measured value.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting:
setting: Expert
setting:
Set this menu item to "On" if the "Primary
Variable" for current output 1 must also be
transmitted as a 4...20 mA signal. If this
menu item is set to "Off', this stops the
4...20 mA signal and starts HART® multi-
drop mode.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting: Expert
setting:
setting:
A polling address more than 0 will start
HART® multi-drop mode. If you start
HART® multi-drop mode, the current output
stays constant at 4 mA.
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting: Operator
setting:
setting:
Use this menu item to change the Tag name.
It can have a maximum of 8 characters. For
more data about the characters available,
Keypad functions
refer to
in menu items).
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
Minimum access level to change the
setting:
setting: Operator
setting:
setting:
www.drexelbrook.com
Selection list
min-max:
3.5...3.6 mA
min-max:
21.0...21.5 mA
min-max:
0.0...25.0 mA
min-max:
0.0...25.0 mA
On, Off
000...063
—
on page 62 (values
OPERATION
6
Default
3.5 mA
21.5 mA
4 mA
20 mA
On
0
TANK01
83
Advertisement
Table of Contents
