Protection Of The Device Settings (Access Levels) - Ametek DR6500 Handbook

DR6500

6.3.2 Protection of the device settings (access levels)

The settings of this device have three different access levels: "User", "Operator" and "Expert".
"Expert" is the highest access level. The highest access level lets you change all available
functions.
Access levels and applicable functions in Program mode
Access level Access level Access level Access level
Expert
Operator
User
If your access level is too low, the display will show a "lock" symbol adjacent to menu items in
Program mode. If it is necessary to change a setting, move the cursor to the menu item, push [> > > > ]
and enter the password used at this time for that menu item.
Figure 6-3: Lock symbol
1 Lock symbol. If the display shows this symbol, you cannot change the setting.
How to change the password
• Push [> > > > ] to enter Program mode.
• Push 2 × [ ], [> > > > ], 5 × [ ], [> > > > ], [ ] and [> > > > ] to go to the menu C7.2 Security.
• Push [> > > > ] to enter menu item C7.2.1 Login.
DR6500-PM-English-Issue 1
Default Default Default Default Applicable functions in Program mode (overview) Applicable functions in Program mode (overview) Applicable functions in Program mode (overview) Applicable functions in Program mode (overview)
password password
password password
•
0058 Read: Measurement data and error messages available at the
"User" access level (Normal mode and menu items B2 Actual
Values and C7.3.1 Message View)
•
Change: All sub-menus in menus A Quick Setup, B Test and C Full
Setup
NOTE: NOTE: You can change the password for the "Expert" access level in
NOTE: NOTE:
menu item C7.2.2 Change Password. Refer to the INFORMATION!
note that follows.
•
0009 Read: Measurement data and error messages available at the
"User" access level (Normal mode and menu items B2 Actual
Values and C7.3.1 Message View)
•
Change: All HART® settings (C5) – but not C5.1.1 Current Loop
Mode
NOTE: NOTE: You can change the password for the "Operator" access level
NOTE: NOTE:
in menu item C7.2.2 Change Password. Refer to the INFORMATION!
note that follows.
•
—
Read: Measurement data and error messages (Normal mode and
men items B2 Actual Values and C7.3.1 Message View)
•
Read: All settings in menus A Quick Setup, B Test and C Full Setup
•
Change: All settings in menu C6 Display (language, backlight
on/off, screen contrast and measurement data display options
(Normal mode, pages 1 and 2)) and C7.5 Units (length, volume,
mass and custom units)
•
Change: Access level. Go to menu item A3 Login or C7.2.1 Login to
change from "User" to "Operator" or "Expert" access levels
www.drexelbrook.com
OPERATION
6
59