Ametek DR6500 Handbook page 121

DR6500
Input and output
Current output Current output Current output Current output
Output signal
Output type
Resolution
Temperature drift
Error signal
HART® HART HART HART
Description
Version
Load
Digital temperature drift
Multi-drop operation
Available drivers
PROFIBUS PA (pending) PROFIBUS PA
PROFIBUS PA PROFIBUS PA
Type
Function blocks
Device power supply
Polarity sensitivity
Basic current
DR6500-PM-English-Issue 1
Standard: 4...20 mA
Options: 3.8...20.5 mA acc. to NAMUR NE 43; 4...20 mA (reversed); 3.8...20.5 mA
(reversed) acc. to NAMUR NE 43
Passive
±5 µA
Typically 50 ppm/K
High: 21.5 mA; Low: 3.5 mA acc. to NAMUR NE 43
Digital signal transmitted with the current output signal (HART® protocol)
7.4
≥ 250 Ω
Max. ±15 mm / 0.6¨ for the full temperature range
Yes. Current output = 4 mA. Enter Program mode to change the polling address
(1...63).
FC475, AMS, PDM, FDT/DTM
PROFIBUS MBP interface that agrees with IEC 61158-2 with 31.25 kbit/s; voltage
mode (MBP = Manchester-Coded, Bus-Powered)
1 × Transducer Block Level (TB-Level), 1 × Physical Block (PB), 4 × Analog Input
Block (AI), 1 × Totalizer Function Block (TOT)
9...32 V DC – bus powered; no additional power supply required
No
18 mA
www.drexelbrook.com
TECHNICAL DATA
8
1
121