Ametek DR6500 Handbook page 72

OPERATION
6
Menu Function
No.
A4 Application Assistant A4 Application Assistant A4 Application Assistant A4 Application Assistant
A4.1 Standard Setup
A4.2 Empty Spectrum
72
Function description
This starts a quick set-up procedure
applicable to most applications. You
can set the length unit, installation
specifications (tank type, tank height
etc.) and current output specifications
(0% range, 100% range, error function
etc.). For more data about the
functions, refer to Table C – Full
Setup, in this section. For more data
about the procedure, refer to
Standard setup
on page 90.
Minimum access level to do the Minimum access level to do the Minimum access level to do the Minimum access level to do the
procedure: Expert procedure:
procedure: procedure:
Fixed and moving objects in the tank
cause interference signals. Put them
through this filter to correctly
measure the tank contents. This
menu item starts a quick set-up
procedure. We recommend that the
tank is empty or only filled to the
minimum level before you do the
procedure. We also recommend that if
you installed the device on a tank that
has equipment with parts that move
(e.g. agitators), start the equipment.
Set the Save Spectrum? Save Spectrum? Save Spectrum? Save Spectrum? step to "Yes",
Empty Spectrum Enable Empty Spectrum Enable Empty Spectrum Enable step to Empty Spectrum Enable
"Enable" at the end the procedure and
set the Save Configuration? screen to
"Yes" to use the data. For more data
about the procedure, refer to
spectrum recording on page 93. Refer
also to "How to make a filter to
remove radar signal interference" on
page 104.
Minimum access level to do the Minimum access level to do the
Minimum access level to do the Minimum access level to do the
procedure: procedure: Expert
procedure: procedure:
www.drexelbrook.com
Selection list
Empty
DR6500
Default
DR6500-PM-English-Issue 1