Platform; Boom - JLG 1250AJP Operation & Safety Manual

4.15 PLATFORM

4.15.1 Platform Level Adjustment
Only use the platform leveling override function for slight leveling of the platform.
Incorrect use could cause the load/occupants to shift or fall. Failure to do so could
result in death or serious injury.
Note: When the Boom Control Select Switch is in the Manual mode, Platform leveling
only functions during Main Lift operation. When the Boom Control Select Switch
is in the Automatic mode, Platform Leveling is active during all functions except
during telescope operation. Also, when in the Manual mode, the Controlled Arc
and Controlled Angle systems are not active.
During normal operation of the machine, the platform will automatically
maintain its position.
To manually level Up or Down - Position the Platform/Level control switch Up
or Down and hold until the desired platform position is obtained.
Note: Platform Leveling is active during all functions except during main boom tele-
scope operations.
4.15.2 Platform Rotation
To rotate the platform to the left or right, use the Platform Rotate control
switch to select the direction and hold until the desired position is reached.

4.16 BOOM

A red tilt warning light is located on the control console which lights when the
chassis is on an excessive slope. Do not swing or raise boom above horizontal when
indicator is lit.
Do not depend on the tilt warning light as a level indicator for the chassis. The tilt
warning light indicates chassis is on an excessive slope. Chassis must be level
before swinging or raising boom above horizontal or driving with the boom
elevated.
1250AJP
WARNING
WARNING
31222384
Machine Operation
73