Table of Contents
Advertisement
IAC-D Installation Plan and Unpacking
2.2.1 Environmental Considerations
The life of the IAC-D is adversely affected if the installation does not meet the following
guidelines:
The system must be installed on a level floor suitable for computer or electronic
equipment.
The system must be installed in a temperature and humidity controlled indoor area free
of conductive contaminants.
Failure to follow guidelines may void your warranty.
2.2.2 Preparing for Wiring the IAC-D
Preassembled power wiring harnesses for a line-up–and–match IAC-D are optional and
must be ordered separately.
Wiring requirements for an IAC-D installed separate from the UPS cabinet, including the
minimum AWG size of external wiring, can be found on Drawing 164201591-6 starting on
page A-16. The input power wiring connections for this equipment are rated at 90°C. If
wire is run in an ambient temperature greater than 40°C, higher temperature wire and/or
larger size wire may be necessary.
2.3 Inspecting and Unpacking the IAC-D
The cabinet is shipped bolted to a wooden pallet (see Figure 2-1) and protected with outer
protective packaging material.
The IAC-D is heavy (see Table A on page A-4). If unpacking instructions are not closely
followed, the cabinet may tip and cause serious injury.
1. Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact your Eaton
service representative immediately.
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site,
NOTE
(see Table A on page A-4 for cabinet weight).
2-2
or as close as possible, before unpacking. Insert the forklift or pallet jack's forks
between the pallet supports on the bottom of the unit.
Verify that the forklift or pallet jack is rated to handle the weight of the cabinet
EATON Powerware
9390 IAC-D Installation and Operation Manual S 164201591 Rev B powerware.com
®
C A U T I O N
C A U T I O N
Advertisement
Table of Contents
