Figure 3-4. 160 Kva Ups With Line-Up-And-Match Iac-D - Eaton Powerware 9390 IAC-D Installation And Operation Manual

Installing the IAC-D
3. If not already open, unfasten the front door latch and swing the door open.
4. If not already removed, remove the door. Remove the retaining screws located
5. Remove the screws securing the top internal safety shield panel covering the input
6. Remove the optional field kit from the bottom of the cabinet and retain for later
7. If necessary, remove the cosmetic cover and hanger brackets from the right-hand
8. If necessary, remove the cosmetic cover and hanger brackets from the left-hand
9. Remove the screws securing the inside distribution panel door, and swing the door
10. Remove the knockouts, as required, on the bottom right side of the UPS cabinet
3-6
EATON Powerware
Figure 3-4. 160 kVA UPS with Line-up–and–Match IAC-D
inside the door at the top and bottom hinge pivot points, then lift the door off.
Save the retaining screws for reinstallation of the door.
terminal compartment and remove the panel to gain access to the optional field
kit (see Drawing 164201591-8, sheet 4 of 6).
use.
side of the UPS. Save the cover, screws, and brackets for later use.
side of the IAC-D. Save the cover, screws, and brackets for later use.
open.
inside panel. Refer to the applicable Powerware 9390 Installation and Operation
manual, listed in paragraph 1.5, for the location of the knockout plug.
9390 IAC-D Installation and Operation Manual S 164201591 Rev B powerware.com
®