Table of Contents
Advertisement
Chapter 3
3.1 Preliminary Installation Information
Refer to the following while installing the IAC-D:
3.2 Unloading the Powerware 9390 IAC-D from the Pallet
The IAC-D is bolted to a wooden pallet supported by wood skids. To remove the pallet,
perform the following procedure:
EATON Powerware
9390 IAC-D Installation and Operation Manual S 164201591 Rev B powerware.com
®
Installing the IAC-D
Installation should be performed only by qualified personnel.
Appendix A for installation drawings and additional installation notes.
Dimensions are in millimeters and inches.
Do not tilt the cabinets more than
The conduit landing plates are to be removed to add conduit landing holes, or remove
knockouts, as required. Plate material is 16 gauge steel (1.5 mm/0.060" thick).
The cabinets must be installed on a level floor suitable for computer or electronic
equipment.
See Table A on page A-4 for equipment weight and point loading.
Refer to the applicable Powerware 9390 Installation and Operation manual, listed in
paragraph 1.5, for UPS cabinet installation, wiring information, and conduit and terminal
locations.
The IAC-D is heavy. See Table A on page A-4 for weight of cabinets. If unloading instructions
are not closely followed, the cabinet may cause serious injury.
Do not tilt cabinets more than 10
1. If not already accomplished, use a forklift or pallet jack to move the cabinet to the
installation area, or as close as possible, before unloading from the pallet. Insert
the forklift jacks between the skids on the bottom of the unit.
Verify that the forklift or pallet jack is rated to handle the weight of the cabinet
NOTE
(see Table A on page A-4 for cabinet weight).
W A R N I N G
10° during installation.
W A R N I N G
C A U T I O N
°
from vertical.
3-1
Advertisement
Table of Contents
