1: Input Point Mapping; 2: Output Circuit Mapping - Honeywell 6820 Manual

Programming Overview
7.2.1 Input Point Mapping
Input points are assigned to input zones, as Figure 7.2 shows. Any input point can be assigned to any input zone. (Input points can be
assigned to one zone only. An input point can be designated as "Unused," which means it has not been assigned to a zone).
7.2.2 Output Circuit Mapping
Figure 7.3 is a simple example showing how to assign notification and relay output circuits to groups.
76
point 1
point 2
point 3
point 4 point 4
point 5 point 5
point 6 point 6
point 7 point 7
point 8 point 8
through
point 1105
point 1106
point 1107
point 1108
point 1109
point 1110
Figure 7.2 Input Point Assignment Example
output circuit 1
NAC circuit
output circuit 2
NAC circuit
output circuit 3
NAC circuit
output circuit 4
aux power output
Aux power outputs are not
mapped to output groups.
output circuit 5
Relay 1
output circuit 6
Relay 2
Figure 7.3 Assigning Output Circuits to Groups (Example)
zone 1
zone 2
zone 3
zone 4
zone 5
zone 6
through
zone 248
zone 249
zone 250
In this example, all NAC outputs
group 1
are assigned to group 1.
group 2
through
group 998
JumpStart creates group 998 and
group 999 for Relay 1 and Relay 2.
group 999
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
Mapping Overview