Delayed Digital Output 1 & 2 - Danfoss Vacon NXP Applications Manual

Description of parameters
5.5.2 Delayed digital output 1 & 2
2.5.2.1 Dig.Out 1 Signal
2.5.3.1 Dig.Out 2 Signal
Connect the delayed DO1 signal to the digital output of your choice with this parameter.
2.5.2.2 DO1 Content
2.5.3.2 DO2 Content
0 = Not used
1 = Ready
2 = Run
3 = Fault
4 = Fault inverted
5 = FC overheat warning
6 = Ext. fault or warning
7 = Ref. fault or warning
8 = Warning
9 = Reverse
10 = SynchronisedToD7
11 = Start Command given
12 = FB DIN2
13 = FB DIN3
14 = ID.Bit DO, See P2.4.x.5
2.5.2.3 DO1 ON Delay
2.5.3.3 DO2 ON Delay
2.5.2.4 DO1 OFF Delay
2.5.3.4 DO2 OFF Delay
With these parameters you can set the on and off delays to digital outputs.
24-hour support: +358 (0)201 212 575 • Email: vacon@vacon.com
On
Delay
Signal
DO
Figure 24. Digital outputs 1 and 2, on- and off-delays
Off
Delay
vacon · 77
5