Id Functions; Value Control - Danfoss Vacon NXP Applications Manual

110 · vacon
P2.13.3 Synch Gain
The phase synchronisation gain. The frequency reference at 180 degree difference.
P2.13.4 Phase Synch Ramp Time
The ramp time for the synchronisation function. When the synchronisation mode is after
the ramp, this time is active all the time.
If the synchronisation mode is before ramp, this time is activated when the angle
difference is less than the value of Ramp Change Hyst.
P2.13.5 Max Synch Correction 1992
This parameter defines how much correction the phase synchronisation can make. The
value 3070 equals to Synch Gain value.
P2.13.6 Ramp Change Hysteresis.
This parameter defines the limit when the phase synchronisation starts to use the ramp
time defined by P2.13.4. Before this, ramp time P2.3.1 is used.
5.14

ID functions

Here you will find the functions that use the parameter ID number to control and monitor the signal.
5.14.1

Value control

The value control parameters are used to control an input signal parameter.
P2.14.1.1 Control Input Signal ID ID1580
With this parameter you can select which signal is used to control the selected
parameter.
P2.14.1.2 Control Off Limit
This parameter defines the limit when the selected parameter value is forced to Off
value.
P2.14.1.3 Control On Limit
This parameter defines the limit when the selected parameter value is forced to On
value.
P2.14.1.4 Control Off Value
This parameter defines the value that is used when the used input signal is below Off
limit.
P2.14.1.5 Control On Value
This parameter defines the value that is used when the used input signal is above On
limit.
5
1778
1777
1894
"ContrInSignal ID"
ID1581 "Contrl Off Limit"
ID1582 "Contrl On Limit"
ID1583 "Contrl Off Value"
ID1584 "Contrl On Value"
Tel. +358 (0)201 2121 • Fax: +358 (0)201 2121 205
Description of parameters