Danfoss Vacon NXP Applications Manual page 29

Monitoring signals
V1.3.2 FB Status Word
This is referred as GeneralStatusWord in the fieldbus manual. See details in the fieldbus
manual.
b0 Ready On
Ready Run
b1
b2 Running
b3
b4 Run Enabled
Quick Stop
b5
b6 Switch On Inhibit
Warning
b7
b8 At Reference
Fieldbus Control
b9
Above Limit
b10
FB_SW_B11
b11
b12 FB_SW_B12
b13 FB_SW_B13
b14 FB_SW_B14
Watchdog
b15
24-hour support: +358 (0)201 212 575 • Email: vacon@vacon.com
ID 68
FB Status Word ID68
Signal
0 = Drive not ready to charge
1 = Drive ready to charge
0 = Drive not ready to run
1 = Drive ready to run and MCB is ON
0 = Drive not running
1 = Drive running with regenerative control ON
0 = No active fault
Fault
1 = Fault is active
0 = Run Disabled by I/O Commands
1 = Run Enabled by I/O Commands
0 = Quick Stop Active
1 = Quick Stop Not Active
0 = CB Control OK
1 = CB Requested open but DC is high
0 = No warning
1 = Warning active
0 = DC Voltage Ref and Act DC Voltage are not same.
1 = DC Voltage Ref and Act DC Voltage are same.
0 = Fieldbus control not active
Active 1 = Fieldbus control active
0 = DC voltage is below the level specified by P2.5.7.4
1 = The DC voltage is above the level specified by
P2.5.7.4
Select bit in G2.10 Fieldbus
Select bit in G2.10 Fieldbus
Select bit in G2.10 Fieldbus
Select bit in G2.10 Fieldbus
Comment
vacon · 27
3