Activation Of The Rear Pto Shaft - Independent Revolutions - Stationary Working Mode - Zetor CRYSTAL HD 150 Operator's Manual

Activation of the rear PTO shaft - independent revolutions - stationary working mode

PTO shaft revolutions speed is dependent on engine revolutions.
With the engine running while the rear PTO shaft clutch disengaged:
A - Select the appropriate operating mode by the PTO shaft speed selector lever.
B - Select the appropriate speed using the rear PTO shaft speed selector button.
C - Move the reverse gear lever to neutral (N).
D - Move the main gear lever to neutral (N).
E - We brake the tractor by a handbrake.
F - We leave the driver's seat.
G - Press the button on the panel on right fender for at least one second or the button on the rear fender of
the tractor for at least three seconds to bring the rear PTO shaft into operation.
When pressing the button the operator must not sit on the driver's seat.
H - Rear PTO shaft rotation and selected rear PTO shaft mode are indicated by the number of revolutions of
the rear PTO shaft and the pictogram of working mode on the dashboard..
To interrupt the torque transmitted by the rear PTO shaft, press the button on the panel on
right fender or the button on the rear fender of the tractor.
If the operator sits in the driver's seat during
work with the rear PTO shaft in stationary mode, the
mode automatically switches to normal mode,
indicated by a change in the pictogram on the
dashboard.
If the operator unblocks the handbrake of the
tractor while working with the rear PTO shaft in
stationary mode, the audible signal sounds and the
rear PTO shaft switches off .
DRIVE OF AGRICULTURAL MACHINERY
FHD18N049
FHSX18N012
139