Activation Of The Rear Pto Shaft - Independent Revolutions - Stationary Working Mode - Zetor MAJOR CL Operator's Manual

Activation of the rear PTO shaft - independent revolutions - stationary working mode

The number of PTO shaft revolutions depends on the number of engine revolutions.
When the tractor is not going with its engine running:
A - Use the lever (1) to select appropriate revolutions of the rear PTO shaft - 540 or 1,000 rpm
C - Pull the manual clutch lever to the upper position and use the hand brake to brake the tractor.
C - Leave the driver's seat.
D - Move the lever for activation of the PTO shaft drive from the position (n) to the position (b).
After the manual clutch lever is released to the lower position, the rear PTO shaft starts to rotate.
During operation of the rear PTO shaft in the independent rotation mode - stationary working
mode - the operator must not sit on the driver's seat.
Pull the clutch release lever for the manual deactivation of the rear PTO shaft for short-term interruption of
torque transmission from the engine.
Move the lever for activation of the PTO shaft drive to the position (n) for long-term interruption of torque
transmission from the engine.
The number of revolutions of the independent PTO shaft see the Chapter Main technical parameters.
If the operator, when working with the rear PTO shaft in the stationary working mode, sits on
the driver's seat, the working mode automatically changes to the common mode.
Rear PTO shaft - dependent revolutions
With dependent revolutions of rear PTO shaft the number
and the direction of PTO shaft revolutions is dependent on
the shifted gear of reversing lever, engaged speed gear
and the group of gears engaged by reduction lever.
PTO shaft drive engagement lever must be shifted in (a)
position.
Depressing the clutch pedal serves for short-term
interruption of torque transmission from engine.
It is necessary to shift the lever of PTO shaft drive
engagement to (n) position or to shift the lever of gears or
the lever of road and reduced speeds to (n) position for
longer interruption of torque from engine.
Manual disengagement of PTO shaft clutch
lever is shifted in (a) position non-functional with
lever of PTO shaft drive engagement.
The number of dependent PTO shaft revolutions, see
Main technical parameters chapter.
DRIVE OF AGRICULTURAL MACHINERY
MCL18N029
65
NM13N007