Table of Contents
Advertisement
Display of revolutions of PTO shafts
When the PTO shaft is switched on, the PTO shaft speed
is displayed on the instrument panel display.
1 - RPM of the front PTO shaft
2 - RPM of the rear PTO shaft
Replaceable end points of rear PTO shaft
The tractor is equipped with six or twenty-one splined
replaceable end point of rear PTO shaft.
Replacement procedure:
1. Use safety ring pliers to demount a safety ring (1)
2. Remove replaceable end point by pulling in the
direction of an arrow (2)
3. Mount the end point in an opposite way, pay increased
attention to the mounting of the safety ring (1)
Replacement of the terminal shall be performed
when the engine is stopped.
Rpm of the output shaft and terminal type shall be
chosen depending on the prescribed rpm of the
coupled mechanism.
Shifting 540, 1,000, 1,000E or 540E min
regardless to the number of splines of the installed
terminal.
Control elements of PTO shafts
The buttons for activation of PTO shafts
Turning the PTO shaft on (at min. 1500 rpm) and off is
done by the buttons located on the panel on the right rear
fender.
1 - switch for turning on and of the rear PTO shaft
2 - switch for turning on and of the front PTO shaft
If the engine is switched off while the rear or
front PTO is switched on, the PTO is switched off after
the engine has been restarted.
132
DRIVE OF AGRICULTURAL MACHINERY
-1
is possible
FHSX18N003
E357
fhd18n041
Advertisement
Table of Contents
