Table of Contents
Advertisement
Activation of the rear PTO shaft - independent revolutions - stationary working mode
The number of PTO shaft revolutions depends on the number of engine revolutions.
When the tractor is not going with its engine running and the clutch of the rear PTO shaft is deactivated:
A - Use the gear shift lever to select suitable speed of the rear PTO shaft.
B - Set proper display of revolutions on the display of the instrument panel according to selected revolutions
of the rear PTO shaft.
C - Move the gear shift lever of dependent and independent engine speed to the upper position to gear
independent revolutions of the rear PTO shaft.
D - Brake the tractor with the hand brake.
E - Move the reversing gear lever to the neutral (N) position.
F - Leave the driver's seat.
G - Press the button on the right pillar of the cabin (on the panel of the outer hydraulic control) for at least
one second or on the rear mudguard of the tractor for at least three seconds to activate the rear PTO shaft.
The operator must not sit on the driver's seat when pressing the button.
H - Rotation of the rear PTO shaft and the working mode of the rear PTO shaft are indicated by displaying
the number of revolutions and the pictogram of the working mode on the display of the instrument panel.
Press the button on the right pillar of the cabin (on the panel of the outer hydraulic control
according to the tractor equipment) or on the rear mudguard of the tractor to interrupt the torque
transmitted by the rear PTO shaft.
If the operator, when working with the rear PTO
shaft in the stationary working mode, sits on the
driver's seat, the working mode automatically
changes to the common mode; this state is indicated
by a changed pictogram on the instrument panel.
If the operator, when working with the rear PTO
shaft in the stationary working mode, moves the
tractor, an audio signal is generated and the rear PTO
shaft is deactivated.
PTO DRIVE OF AGRICULTURAL MACHINES
PGPPN009
P18N023
113
Advertisement
Table of Contents
