Driving Operation; Starting The Engine; Blocking Of The Start; Non-Permitted Starting - Zetor CRYSTAL HD 150 Operator's Manual

DRIVING OPERATION

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.

Starting the engine

After connecting the battery using the battery disconnecting switch, wait at least 30 seconds
before turning on the ignition key.
FHD18N018
1 - When starting the engine, the operator must sit on the driver's seat.
2 - Handbrake the tractor.
3 - Move the PTO shaft speed lever to neutral position.
4 - Insert the key into the ignition switch - position 0.
5 - Depress the clutch pedal.
6 - Move the main shift lever to neutral.
7 - Move the reversing lever under the steering wheel to neutral.
8 - Switch the ignition key from position 0 to position I. The glow plug light lights up.
9 - Wait until the glow plug light goes off (the time depends on the coolant temperature).
10 - Turn the key from position I to position II (start) immediately after the lamp switches off (max. 5 sec).
11 - When the engine is started, release the ignition key immediately, it will automatically return to position I.
Do not start for more than 20 s.
12 - Loosen the clutch pedal.

Blocking of the start

If the engine cannot be started and the defect signal lamp is flashing, it means that blocking of the start was
activated by electronic regulation of the engine and this way the engine is protected.
The blocking of the start is interrupted when the key in the switch box for about 30 seconds is moved to
position 0.

Non-permitted starting

It is prohibited to start the tractor by
short-circuiting the terminals of the starter. Perform
starting from the driver's seat only. During any
handling or repair of the starter, the minus pole of the
battery and all gear shift levers, including shifting of
the PTO shaft, must be in the neutral position. The
terminals of the starter are covered with a cover.
pikt_2
89