Activation Of The Front Pto Shaft - Stationary Working Mode; Deactivation Of The Front Pto Shaft - Zetor CRYSTAL HD 150 Operator's Manual

Activation of the front PTO shaft - stationary working mode

PTO shaft revolutions speed is dependent on engine revolutions.
With the tractor stopped while the engine is running:
A - We brake the tractor by a handbrake.
B - Reverse gearshift lever must be shifted to neutral position.
C - Main gearshift lever must be shifted to neutral position.
D - We leave the driver's seat.
E - Pressing the button on the right fender for at least one second puts the front PTO shaft into operation.
When pressing the button the operator must not sit on the driver's seat.
F - Rotation of the front PTO is indicated by the number of revolutions on the dashboard. The mode of
If the operator sits in the driver's seat during
work with the front PTO in stationary mode, the mode
automatically switches to normal mode, indicated by
a change in the pictogram on the dashboard.
If the operator unblocks the handbrake of the
tractor while working with the front PTO shaft in
stationary mode, the audible signal sounds and the
front PTO shaft switches off .

Deactivation of the front PTO shaft

Pressing the button on the right fender will switch off the
front PTO shaft. This status is signaled by not showing the
number of revolutions of the front PTO on the dashboard
display.
DRIVE OF AGRICULTURAL MACHINERY
FHD18N053
P18N023
F18N054
143