Setting Of Steering Sensors Of The Front Axle; Display - Machined Area - Zetor CRYSTAL HD 150 Operator's Manual

INSTRUMENT PANEL

Setting of steering sensors of the front axle

C18N021
Front axle turn sensors
- with any front axle geometry intervention.
- When replacing the front axle turn sensors.
- When replacing the instrument panel.
- When replacing the front axle.
Calibration procedure
- Mark the 15 m long track in a suitable space.
- Inflate tractor tires to the prescribed pressure.
- Start the engine.
- Pull the tractor to the beginning of the track.
- Enter the service menu by pressing the button (B) for a longer time.
- Use the (C) and (D) keys to select the settings item marked with the arrow (1). By pressing the button (B)
enter the menu
- Use the (C) and (D) keys to select the steering item marked with the arrow (2). By pressing the button (B)
enter the menu
- Drive the tractor straight 15 meters forward and stop the tractor.
- Press the (A) button to save the values and return to the primary screen. Display - machined area
The processed area display shows the processed area in
hectares.
1 - processed area in hectares
2 - processed area - average in hectares per hour
3 - fuel consumption - average in litres per hectare
4 - fuel consumption in litres from the start of the recording
of the processed area.
The width of the processed area (i.e., the work
width of the tools) must be set for proper calculation
of the processed area.
PHS18N008
69