Table of Contents
Advertisement
Front PTO shaft
Front PTO shaft is equipped with a solid six or twenty-one
splined end point and it comes only in design of 1,000
revolutions.
Tractor may be equipped with front PTO shaft with varied
direction of spinning:
a -
In compliance with the direction of engine
revolutions (standard)
b -
Against the direction of engine revolutions
(*on request)
Activation of the front PTO shaft -
PTO revolutions speed is dependent on engine
revolutions.
With the tractor stopped while the engine is running: ´
A - Pressing the button on the right pillar of the cab for at
least one second puts the front PTO shaft into operation.
When pressing the button the operator must sit
on the driver's seat.
B - Rotation of the front PTO is indicated by the number of
revolutions on the dashboard. The mode of operation is
indicated by a pictogram on the dashboard display.
If the front PTO shaft is active, the tractor is not going and the operator leaves the driver's seat,
an audio signal is generated and after five seconds the rear PTO shaft is automatically deactivated.
Reactivation is performed when the operator sits on the driver's seat by pressing the button on the
right column of the cabin.>
If the front PTO shaft is active, the tractor is going and the operator leaves the driver's seat, an
audio signal is generated.
142
DRIVE OF AGRICULTURAL MACHINERY
C18N107
FHD18N052
Advertisement
Table of Contents
