Danfoss VLT AutomationDrive FC 302 Design Manual page 151

Electrical Installation Con...
Illustration 10.5 Control card wiring path for the E1h. Same
routing path for enclosures E2h and D1h–D8h.
10.4.2 Control Terminals
Illustration 10.6 shows the removable drive connectors.
Terminal functions and default settings are summarized in
Table 10.5 – Table 10.7.
MG38C202
Design Guide
Illustration 10.6 Control Terminal Locations
1
2
1 Serial communication terminals
2 Digital input/output terminals
3 Analog input/output terminals
Illustration 10.7 Terminal Numbers Located on the Connectors
Terminal
61
68 (+)
69 (-)
Table 10.5 Serial Communication Terminal Descriptions
Danfoss A/S © 01/2018 All rights reserved.
61 68 69 39 42 50 53 54 55
12 13 18 19 27 29 32 33 20 37
Parameter Default Description
setting
– – Integrated RC-filter to
connect cable shield
if there are EMC
problems.
Parameter – RS485 interface. A
group 8-3* FC switch (BUS TER.) is
Port Settings provided on the
control card for bus
Parameter –
termination
group 8-3* FC
resistance.
Port Settings
3
10 10
149