Swann AMI Phosphate-II Operator's Manual page 93

AMI Phosphate-II
Default Values
Relay1/2
Input:
Miscellaneous
Interface
A-96.250.641 / 290312
Function:.......................................................................... limit upper
Parameter:.................................................................... Phosphate 1
Setpoint: ............................................................................ 10.0 ppm
Hysteresis:......................................................................... 0.10 ppm
Delay: .................................................................................... 30 Sec
If Function = Control upw. or dnw:
Parameter:.................................................................... Phosphate 1
Settings: Actuator: .......................................................... Frequency
Settings: Pulse Frequency:..................................................... 120/m
Settings: Control Parameters: Setpoint: .......................... 10.00 ppm
Settings: Control Parameters: P-band:.............................. 0.10 ppm
Settings: Control Parameters: Reset time: .............................. 0 Sec
Settings: Control Parameters: Derivative Time:....................... 0 Sec
Settings: Control Parameters: Control Timeout: ...................... 0 Min
Settings: Act. Time proportional: ........................... Cycle time: 60 s,
Settings: Act. Time proportional: ..................... Response time: 10 s
Settings: Act. Motor valve:......................................... Run time: 60 s
Settings: Act. Motor valve:.................................... Neutral zone: 5%
If Function = Timer:
Mode: Interval:........................................................................ 1 min.
Mode: daily/weekly: ...................................... Starting time: 00.00.00
Run time: ............................................................................... 10 Sec
Delay: ...................................................................................... 5 Sec
Signal output:............................................................................ cont.
Output/Control: ......................................................................... cont.
Active............................................................................ when closed
Signal Outputs ........................................................................... hold
Output/Control .............................................................................. off
Fault.............................................................................................. no
Delay ..................................................................................... 10 Sec
Language:............................................................................. English
Set default: ................................................................................... no
Load firmware:.............................................................................. no
Password:........................................................... for all modes 0000
Sample ID:....................................................................... - - - - - - - -
Protocol: ................................................................... Hyper Terminal
91