Interface - Swann AMI Phosphate-II Operator's Manual

AMI Phosphate-II
Installation

3.13. Interface

Interface
RS232
Interface
RS485
30
Terminal 50, 52, 53
The AMI Interface RS232 PCB is used for Logger down load and
Firmware up load. For detailed information see the corresponding
manual "AMI RS232 Interface".
RS232 Interface PCB
Terminal 37 PB, Terminal 38 PA
To connect several instruments by means of a network or to config-
ure a PROFIBUS DP connection, consult the PROFIBUS manual.
Use appropriate network cable.
Note: The switch must be ON, if only one instrument is
installed, or on the last instrument in the bus.
A
RS485 Interface PCB
A On - OFF switch
A-96.250.641 / 290312