Changing Parameters And Values - Swann AMI Phosphate-II Operator's Manual

AMI Phosphate-II
Operation
5.4.
Changing
parameters
Changing
value
38

Changing Parameters and Values

The following example shows how to change the log interval:
Logger Sensors
Sensor type
Log interval
Disinf. Free chlorine
Clear logger
Temperature
Standards
Sensors
Interval.
Log interval
Clear logger 10 min
30 min
1 h
event driven
Sensors
Log interval event driven
Clear logger
Sensors
Log interval event driven
Save ?
Clear logger
Yes
No
Alarm Phosphate.
Alarm High 5.00 ppm
Alarm Low 0.00 ppm
Hysteresis 0.10 ppm
Delay
Alarm Phosphate.
Alarm High 1.00 ppm
Alarm Low 0.00 ppm
Hysteresis 0.10 ppm
Delay
Highlight the menu item indicating the
4.4.1 5.1.2
parameter you want to change.
FOME
30 min
no
Enter
Press
NT5K
Press
4.1.3
required parameter.
30min
no
Enter
Press
[Exit] to keep the previous parameter).
4.1.3 The selected parameter is indicated
(but not saved yet).
no
Exit
Press
4.1.3
Yes highlighted, press
the new parameter. The system
no
reboots, the new parameter is set.
5.3.1.1.1
Select parameter and press
5 Sec
5.3.1.1.1
Enter
to confirm new value.
5 Sec
to exit the menu.
Exit
or to highlight the
to confirm the selection (or
Enter
to save
Enter
to set required value.
A-96.250.641 / 290312