Table of Contents
Advertisement
ABS
3. ABS Sequence Control
A: OPERATION
1) While the ABS sequence control is performed,
the operation of the hydraulic unit can be checked
using the brake tester or pressure gauge after the
hydraulic unit solenoid valve operation.
2) ABS sequence control can be started by Subaru
Select Monitor.
1. ABS SEQUENCE CONTROL WITH SUB-
ARU SELECT MONITOR
NOTE:
In the event of any trouble, the ABS sequence con-
trol is not operated.
1) Connect the Subaru Select Monitor to data link
connector under the driver's side instrument panel
lower cover.
2) Turn the ignition switch to ON.
3) Set the Subaru Select Monitor power switch to
ON.
4) Set the Subaru Select Monitor to "Brake Control"
mode.
5) When the "Function check sequence" is select-
ed, the "ABS sequence control" will start.
6) Execute the following operations when the mes-
sage "Press the brake pedal so that the brake ped-
al force is between 100 and 150 kgf" is displayed.
(1) When the brake tester is used, press brake
pedal pad with a force of 1,000 N (102 kgf, 225
lbf).
(2) When using the pressure gauge, press the
brake pedal so as to make the pressure gauge
indicate 3,500 kPa (36 kgf/cm
7) "Press the [YES] key" will be displayed. Press
the [YES] key.
8) The brake line being operated is displayed on
the Subaru Select Monitor.
ABS Sequence Control
2
, 511 psi).
ABS-10
Advertisement
Chapters
Table of Contents
