Subaru Legacy 2005 Service Manual page 3001

C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
(A)
ST-925091000
ST-926470000
ST18675AA000
General Description
TOOL NUMBER
925091000
(B)
926470000
18675AA000
• Use SUBARU genuine grease etc. or the equiv-
alent. Do not mix grease, etc. with that of another
grade or from other manufacturers.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply grease onto sliding or revolution surfaces
before installation.
• Before installing snap rings, apply sufficient
amount of grease to avoid damage and deforma-
tion.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
DESCRIPTION
BAND TIGHTENING Used for tightening boot band.
TOOL (A) Jig for band
(B) Ratchet wrench
AXLE SHAFT Used for removing axle shaft.
PULLER
DIFFERENTIAL Used for installing differential side retainer oil
SIDE OIL SEAL seal.
INSTALLER
DS-7
DRIVE SHAFT SYSTEM
REMARKS