Porsche 928 Workshop Manual page 458

928
Fuel System
25
DISASSEMBLING AND ASSEMBLING MIXTURE CONTROL UNI'I
1. Pre-assemble adjusting lever. spring and fork
lever prior to installation in air flow sensor
housing.
3. Make sure that springs fit properly.
2. This requires a suitable cylindrical pin. e.g.
pin from adjusting lever of 911 mixture con-
trol unit or a standard 8 h 8 x 60 DIN 7 cylin-
drical pin.
Both ends must be chamfered.
4. Guide preassembled parts into air flow sensor
housing and carefully push out pin used for
assembling with the original pin.
Printed in Germany- I. 1978
Disassembling and Assembling
Mixture Control Unit
25 - 21