Porsche 928 Workshop Manual page 693

!I 28
Manual Transmisrion/Conrrolr. Case
34
17. Place floor crane underneath rear axle cross
member. Mark poririon of rear axle cross
member. Remove last 4 bolts on rear axle
cross member. Tilt real axle carefully. making
sure that spring strms or conrrol a,ms do nor
twist. Support rear axle in tilted posirion m
keep rhe entire weight off of the lower control
arm link pins.
Note
Entire rear axle assembly of cars with a welded
battery console must be removed. Mark roe eccen-
tric for installation later and remove eccentric
bolts.
18.
Mount
transmission supporl/bracker on wanr
mission. Remove 6 bolts between central tube
and transmission. as well as Special Tool
US 802!!. Pull back rransmission IO one side
and lower.
Installing
1. Install the marked spacers or spacers of derer-
mined thickness between the transmission mounts
and rear axle cross member (see page 34 8 a).
2. Watch marks of toe eccentric and cross member
IO body when insralling rhe rear axle.
3. Adjust parking brake (see page 46 8).
4. Observe the specified torque values.
Printed inGermany IV. 1980
Removing and Installing Transmission 34 - 7