Porsche 928 Workshop Manual page 656

928
Clutch/Controls
30
a
a
Beginning with 1984 models
'"9, _,
removal will be easier by using 4 mm thick
wire brackets (locally made) underneath the
bolt heads before loosening the mounting
bolts (less force required/brackets bevelled).
In addition, it will not be necessary to
unscrew the mounting bolts in steps of 1 to
1 l/2 turns.
Also refer to point 6 on page 30 - 6 and
point 2 on page 30 - 17.
10. Push back entire clutch (pressure plate,
intermediate ring with starter gear ring,
both clutch discs, release lever, release
bearing sleeve, central shaft I) and
remove downward.
9. Unscrew the clutch mounting bolts one
after the other by 1 to 1 l/2 turns until
pressure is removed from the pressure
plate. Disconnect release lever at ball stud,
by pushing the release lever down toward
the flywheel. Now remove the mounting
bolts.
2. Prior to installation push intermediate
ring at the three adjusting elements in
direction of the release bearing. If
applicable, pre-load clutch pressure plate
(see page 30 - 17).
Printed in Germany - VI I I, 1984
Removing and Installing Clutch 30 - 5
Installing
1. Check and, if necessary, replace clutch
parts prior to installation. Also refer to
"Disassembling and Assembling Clutch",
"Clutch Control Ball Stud Versions" and
"Checking Discs, Pressure Plate and
Intermediate Plate".